切削

The high-speed steel tool was not suitable for turning fluorophlogopite,and ceramics tool was ...

车削氟金云母陶瓷对刀具磨损过程与削金属相似。

The microstructure and property of the free cutting unquenched plastic die steels have been studied.

研究了易削系非调质具钢组织与性能。

With smooth trimmed surface of insole backpart stable trimming quality and high production.

中底踵削面平滑均匀，品质稳定，产量高。

The material cutability is described and evaluated with a target system and the fuzzy comprehensive evaluation method.

试图用指标体系来描述和评价材削加工性。

The characteristic and influencing factors of tools wear were analyzed through turning fluorophlogopite machinable ceramics.

对氟金云母可加工陶瓷进行车削加工试验,分析了削中刀具磨损特性,讨了影响刀具磨损率因素。

This paper describes the cutting test of hard alloy tip produced by using the new carbusintering technique.

对采用烧结碳化新工艺制取硬质合金刀片进行了削试验。

Based on machine kinematics and cutting theories, the simulating method for the generation of three-dimensional surfaces in face turning and flycutting of SPDT is studied.

基于机床运动学和削理对单点金刚石加工时工件端面削及“飞”加工进行了仿真建。

Material removal by machining involves interaction of five elements: the cutting tool, the toolholding and guiding device, the workholder, the workpiece, and the machine.

材削与5个因素有关：刀具，刀具夹具和导向装置，工件夹具，工件和加工机器。

The residual stress formed on the surface of rolling bearing in superfinish hard turning will influence the fatigue life of rolling contacting after stress decay.

超精硬态削在滚动轴承表面形成残余压应力,经工作应力衰减后才成为影响滚动接触疲劳寿命应力状态。

The cutters used in high speed machining(HSM) have poor rigidity, therefore the method fits to HSM of die cavity due to the unfluctuating cutting force characteristic.

其削力平稳特性更适合于具型腔高速数控加工,可以克服高速加工用刀具刚性差不足。

This paper shows that under certain conditons it is possible to diminish and even eliminate the nonlinear distorsion of a peak envelope detector by biasing the diode adequately.

本文对一般所谓惰性失真和削失真同时分析讨而获得统一公式,并且发现对二极管加适当正偏压可以减小或消除失真。

To hit a good drop shot one needs a good slice or underspin shot.A drop shot is really nothing more than an underspin shot that lands short or close to the net.

要放好小球需要有好削球或下旋球技术. 小球只是离网更近更短下旋球.