The lighting of a wood fire begins with small pieces of wood.

人们用小块木柴点火。

She got into the car and switched on the ignition.

她上车后点火发动汽车。

Rake out the cinders before you start a new fire.

在重新点火前先把煤渣耙出来。

I must have left my key in the ignition.

我肯定是把车钥匙忘在点火开关上了。

The product is suitable for the engine portfire of vehicle and tractor.

本产品适用于汽车、拖拉机等发动机高压点火装置。

He turned the ignition key.

他转动钥匙点火。

The investigation showed that after modified PET could be used in electronic junctor, coiler framework, igniting parts.

结果表明,通过适当的改性,PET材料可用来生产连接器、线圈骨架、点火元件等、气元器件。

Taking aft-end igniter design for a rocket motor for example,design methods for ignition sequence,amorce quantity estimation and nozzle closure were described respectively.

以某型发动机尾部点火研究对象,对点火序列、点火药量的估算、喷管堵片的方法进行了阐述。

Retroengine's firing time must the accuracy control, the firing time differ 1 second, will cause the airship point of descent position difference kilometer.

制动发动机的点火时间必须精确控制，点火时间相差1秒钟，就会使飞船落点位置相差数公里。

It is light, firm structure, high breaking voltage, high portfire level, dynamic working stabilization and so on.It is fit to aviation and shipping portfire system.

具有重量轻、结构牢固、点火能级大、动态工作稳定等特点，适用于航空发动机点火系统。

Arcing at the tower will carbonize the cable boot, which if it is connected to a new ignition coil, will cause the coil to fail.

椿上的弧会使线圈的根部烧焦，如果它被连接至新的点火线圈，将会损坏线圈。

The airship establishes the returns posture immediately, the returns cabin and the advancement cabin separates, the retrofire, starts from the outer space to the earth's surface returns.

飞船随即建立返回姿态，返回舱与推进舱分离，制动发动机点火，开始从太空向地球表面返回。

In calefactive phase, the electro thermal model of hot bridge wire was established, the calefactive time of invariable current fire case and capacitance discharge fire case were both studied.

在升温阶段建立桥丝热升温模型，分别求解恒定流点火升温时间和容放点火升温时间。

To increase the precision of the electric igniting parameters of common fusehead, a kind of wrapper such as NC or CMC,can be used to wrap the bridge wire in common fuse head .

了提高普通点火头发火参数的精度,可以在桥丝上涂覆一层硝化棉或羧甲基纤维素的涂层。

The purpose of the bulkhead is threefold: to seal the forward end of the motor, to retain the pyrogen igniter, and to act as a blowout plug in case of motor overpressurization (discussed earlier).

的目的，该舱壁是三个方面：密封着年底汽车，保留热原点火器，并充当井喷堵塞在案件机overpressurization （讨论以较早者准） 。