The freshly abraded specimen must then be washed in industrial spirit and Analar acetone.

然后，研磨好的新鲜必须在工业酒精及纯丙酮中洗涤。

The goods sampled out quite satisfactorily.

货物结果十分令人满意。

Studied the water flowing characteristics in gangue used as water-gravel-mixed filling material from one Uranic mine.

摘要利用某铀矿尾矿作为水砂充填料的水流特性研究，针对不同粒度的，进行常水头渗透验。

The sample was molten and decomposed with sodium peroxide,leached and acidified with hot water and constant-volumed.

以过氧化钠熔融分解,热水浸取、酸化,定容。

After being smelted with fire assay and enriched with cupellation method,the precious metal is decomposed with chloroazotic acid.

火金法熔炼和灰吹富集后,贵金属合粒以王水分解,在盐酸介质中,用火焰原子吸收分光光度法测定钯量。

A high K ratio method for fatigue precracking in welding position toughness specimen of thick steel plate was developed.

提出了预制厚钢板缝断裂韧度疲劳裂纹的“高K比法”。

The inositol in preblend fish feed was detected by ion chromatorgraphy, and the method was simple, rapid and precision.

摘要采用离子色谱技术快速测定鱼预混饲料中肌醇含量。该方法具有制备简单，分析，速度快，结果凖确等特点。

The developed dual phase cast steel is applicable as scaleboard materials in a middle or smaller type of ball mill.

在给定的低铬铸铁下条件下,当冲击载荷较小时,铸态复相耐磨钢具有良好的冲击耐磨性。

The high wearing resistance of the samples after hydrocooling and air cooling was partially attributed to martensite transformation and work-hardening.

水冷和空冷的具有高耐磨性的重要原因是其在磨损过程中诱发了马氏体相变,出现加工硬化现象。

This paper deals with the wear resistance and anti-seizing behavior of sulfonitrided high speed steel by comparing with that without sulfonitriding.

研究了高速钢硫氮共渗处理后的耐磨性及抗咬合性，并与未表面处理的进行了比较。

A preparation method to reveal the grain boundrie of zirconium and zircaloy for metallographic and scanning electronic microscope analysis is introduced.

介绍了一种能清楚显示锆及锆合金晶粒的金相及扫描电镜分析的制备技术。

In this paper the sample preparation techniques of radiolarite were discussed in order to get high quality secondary electron images in SEM.

讨论了为获得放射虫化石的高质量的二次电子图像所采用的制备方法。

The microstructure of the sample glaze layer under polarizing microscope and reflecting microscope has showed acicular hausmannite crystals on the glaze layer sur...

通过偏光显微镜和反光显微镜观察釉层的显微结构,发现虹彩釉在成釉过程中釉层表面析出了针状的黑锰矿晶体。

The photographs of polarizing microscope showed the number of spherocrystal was increased and the diameter was decreased after saponification reaction which was agreed with the studies of DSC.

的偏光显微镜观察结果表明，醇解后，球晶数目增加、直径减小、完善程度降低。

The article expounds the sample decomposition and the method of the sample preparation by applying the method of atomical assimilation spectrum, and lists some specific analytical of metallurgy.

本文对应用原子吸收光谱法分析冶金品过程中的分解和分析品的制备方法进行了较详细的阐述,并列举了几种基体合金的具体分析方法。

The metal reflet glaze samples were prepared with the Huxian wheat-meal-stone accession 0%, 5%, 10% and 15% according to the traditional metal reflet glaze formula and then sintered at 950%.

摘要在金属光泽釉配方基础上，制作了4组户县麦饭石添量为0%，5%，10%，15%的金属光泽釉，在950℃温度环境下烧成。

All the samples include Suzhou satin , Surah and Sangbo satin.There are bleached silk fabrics , dyed silk fabrics and fabrics treated by softener and totally amount of 29 kinds.

包括素绉缎、斜纹绸和桑波缎，其中有练白、染色和加柔软剂整理过的共29种真丝织物。