绝缘的

The effect of process parameters on the electric insulance of micro arc oxidated ceramic coat on aluminium plate is studied.

研究了工艺参数对铝微弧氧化陶瓷层电绝性能影响规律。

The relationship between the wet flashover voltage and the precipitation or the water conductivity was congruous with the power function relation.

淋雨量、雨水电导率大小对支柱绝污雨闪电压影响也较大，且均符合幂函数关系。

Technique of protection insullac of printed circuit board (PCB) has a strong impact on service life of electronic devices in ships.

印制板三防绝处理对舰用电设备使用寿命有很大影响,本文主要探讨印制板三防绝漆喷涂工艺一些改进。

In this paper, attention problems on measurement insulation resistance by megger are proposed, reasons are analyzed, and gives some field examples.

摘要文章提出了兆欧表测量绝电阻应注意问题，分析了原因，并给出了若干实例。

Insulance Ohmmeter, Model ZC25, can be used to measure insulation resistance of various electrical machinery, telecommunication element, household appliances and teaching electrical equipment.

ZC25型绝电阻表可用于测量各种电机、电讯元器件、家用电器及教学电器设备绝电阻。

Grounding and its notices were probed into construction of trolley isolative wire. How to eliminate safe hidden troubles in construction was discussed also.

探讨架空绝线施工时接地问题注意事项及如何消除施工中安全隐患。

Early electrical workers used it as a coating to insulate coils, and molded it into stand-alone insulators by pressing together layers of shellac-impreg-nated paper.

早期电力工用作涂料，隔离缠绕在一起线圈，还注满了紫胶纸一层层地压紧制成单独绝物。

Danyang Xunda Insulation Material Factory is professional provider of hot forming micanite, flexible micanite, mica foil, mica tape, mica V-ring, insulation plastic, conformal mat etc,.

丹阳市迅达绝材料厂，是以研制、产云母板、母箔、母带、母环、工塑料制品、应材料等产品为主绝材料和绝件制品专业生产企业，是铁道部机车重要部件定点生产单位。

The capacitive sensor consisted of two mutual insul ating copper and foil electrodes,clinging to the external w all of infusion bottle with two insulating stretch tight balteum.

电容式液位检测传感器主要由两条相互绝铜箔电极构成,由两条绝弹性锁紧带带状传感器紧贴在输液瓶外壁,传感器与药液不接触,对药液性能不会产生影响。

This heating helps to break down weak spots in the dielectric that otherwise might pass through the electrode undetected, only to fail during a later spark or hipot test.

这热量帮助击穿电线绝较薄地方﹐否则线材通过电极而没有被检测到﹐结果在以后火花测试和高压绝试验会失效。