数值

"Half this number is less than 6 times the tens dight of the number by 4."

的一半比它的十位的6陪小于4.

The IMPOWER(string) returns a complex number raised to a power.

IMPOWER(字符串;) 函返回复的幂。

The parameters of digifax is adjust by the reference of wind tunnel test result.

针对风洞实验的结果对拟的各项参设置进行调整。

The Six Sigma Black Belt should be able to read values from a cumulative frequency ogive.

6西格玛黑应能从累计频次尖顶部读出。

A new method for predicting the motion of the hybrid monohull in regular wave is presented.

给出一种考虑粘性影响的单体复合船型运动预报的方法。

The constraint condition for the strain energy density function of incompressible hyperelasticity is proposed.

通过对各种有限元方法的分析比较，适当修改了已有的应变能密度函的形式使之更适合计算。

57. The Six Sigma Black Belt should be able to read values from a cumulative frequency ogive.

六西格玛黑应该能够从累计频次分布中读出。

If nonnumeric data is input, that read and any subsequent use of the stream will fail.

如果输入非型据，次的读入以及流的后续使用都将失败。

The gust-cascade interaction noise was numerically simulated using computational aeroacoustics by solving the two-dimensional linearized Euler equations.

采用计算气动声学方法求解二维线化欧拉方程对阵风与叶栅的干涉噪声进行了拟。

The transient process that the axialflow in the centrifuge is established under a steady thermal driving isrevealed.

通过求解得到了存在温度驱动情况下，离心机内形成小扰动流场的过程。

The fracturing process induced by different excavation sequence under final highwall with auger mining was numerically simulated.

对到界边坡下采用螺旋钻机开采煤柱不同开采顺序引起的破坏过程进行了拟。

Arff. which contains terms and numerical data sets for test mining weka.

是一基于weka据挖掘的实验测试据集,格式为.arff,里面包含有名词性和型的据集,用于weka挖掘测试.-This is a weka data mining based on the experimental data sets format.

It is calculated as half of the value of the sampling rate.Passing this level causes aliasing distortion, or foldover.

它的计算方法是将采样率除以二，超过将会导致折叠失真，或称折叠。

The Distinct Element Method(DEM)is a discontinuum-based numerical method especially applicable to solve the discontinuity problems in jointed rock mass.

离散元法是基于不连续性假设的方法,它特别适合于求解节理岩体中的非连续性问题。

The two-dimensional axisymmetric subsonic-transonic-supersonic flow in an experimental arcjet thruster is simulated numerically using flux vector splitting method.

摘要对一实验电弧加热式发动机二维轴对称亚跨超音速流动进行了拟，所采用的方法是矢通量分裂算法。

The cross-section curvature ductility ratio for R.C inequiaxial T-shaped, L-shaped and cress-shaped columns is calculated by numerical method.

摘要采用非线性全过程分析方法，计算了钢筋混凝土不等肢T形、L形和十字形柱截面型在多种工况下的截面曲率延性比。

The method simplifies the procedure of the trial function choice, and could be used in numerical calculation in geotechnique engineering.

该方法简化了试函的选择，适用于岩土工程中的各种计算。

Numerical simulations of laminar flow separation and reattachment occurred in an annular backstep passage are performed by the SIMPLER algorithm.

用SIMPLER算法对流过环形后台阶通道内的层流分离和再附着进行了拟。

In the paper, study on displacement law of blank hole for forming cylindraceous with bottom border by numerical simulation technology.

通过仿真研究了底孔的圆筒形件成形后底孔的变形规律,在此基础上建立了底孔的圆筒形件成形后毛料中心孔变形规律的经验公式。

The construction of boundary type cubature is a problem that has been noticed for a very long time in numerical integration.

边界型求积公式是积分法研究方向早就被注意的问题。